Function Setting (Customize Unit)

Connect the SUBARU Select Monitor to the data link connector.
Turn the ignition switch ON.
Select {CHECK INDIVIDUAL SYSTEM} on the «MAIN MENU» screen, and then press the [YES] key.
Select {KEYLESS UNIT MODE} on the «SYSTEM SELECT MENU» screen, and then press the [YES] key.
Select {CUSTOMIZE UNIT} on the «INTEGRATED UNIT MODE DIAGNOSIS» screen, and then press the [YES] key.

Change the contents using the UP/DOWN key, and then set using the [YES] key.

Function Setting (Customize Unit) Item List

FUNCTION SETTING (CUSTOMIZE UNIT) ITEM LIST

No.	Data	Initial setting	Customized setting	Remarks
1	Alarm ON/OFF setting	ON	ON	Operates the alarm (hazard, horn).
1	Alarm ON/OFF setting	ON	OFF	Stops the alarm operation.
2	Alarm monitoring delay setting	ON		After keyless locking, the alarm monitoring operates after the following delay time.
			ON	The delay time is 30 seconds.
			OFF	The delay time is 0 seconds.
3	Impact sensor ON/OFF setting	OFF	ON	Activates the impact sensor function when the setting of the impact sensor is "YES".
3	Impact sensor ON/OFF setting	OFF	OFF	Deactivates the impact sensor function. (For the models without the impact sensor, it should set to "OFF".)
4	Setting with/without impact sensor (Option)	NO	YES	Controls the impact sensor mounted mode. [For the models without the impact sensor, it should be set to "NO". If it is set to "YES", the hazard or horn operates under the keyless lock (start alarm monitoring).]
4	Setting with/without impact sensor (Option)	NO	NO	Controls the impact sensor not mounted mode.
5	Passive ARM switching	OFF	ON	The function automatically shifts to ARM even if the user does not lock (ARM) it on purpose.
5	Passive ARM switching	OFF	OFF	Activates when the passive ARM switching is set to "ON".

After completing the setting, make sure that the contents of the change are adapted to the vehicle equipment in {CURRENT DATA DISPLAY/STORE}.
CAUTION:
- The alarm is operated normally by matching the above setting and the vehicle equipment specification.
- Do not change the setting for items other than the above items during the function setting operation.
- Perform resetting when installing a new keyless unit.
- In the passive mode, the security alarm is operated automatically, but the doors are not locked. At this time, always lock the doors to prevent crime because it is very dangerous.
NOTE: For the details of the operation procedure, refer to the SUBARU SELECT MONITOR OPERATION MANUAL.
Turn the ignition switch OFF, and then remove the SUBARU Select Monitor.