lemon-mirror:
Home >> Subaru >> 2006 >> Baja Base, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> Inhibitor Switch >> Installation

Inhibitor Switch: Installation

  1. Connect the inhibitor switch harness connector to inhibitor switch.
  2. Install the inhibitor switch to transmission case.
    Fig 1: Identifying Inhibitor Switch
    G04990323Courtesy of SUBARU OF AMERICA, INC.
  3. Move the range select lever to neutral position.
  4. Using the ST, tighten the bolts of inhibitor switch. ST 499267300 STOPPER PIN

    Tightening torque: 3.5 N.m (0.36 kgf-m, 2.6 ft-lb) 

    Fig 2: Identifying Inhibitor Switch And Range Select Lever
    G04990324Courtesy of SUBARU OF AMERICA, INC.
  5. Install the select cable to range select lever.
  6. Install the plate assembly to transmission.

    Tightening torque: T:25 N.m (2.5 kgf-m, 18.1 ft-lb) 

    Fig 3: Identifying Plate Assembly And Select Cable
    G04990325Courtesy of SUBARU OF AMERICA, INC.
  7. Install the washer and snap pin to range select lever.
    Fig 4: Identifying Snap Pin, Range Select Lever And Washer
    G04990326Courtesy of SUBARU OF AMERICA, INC.
  8. Install the front and center exhaust pipes. (Non-TURBO model)

    < Ref. to INSTALLATION , FRONT EXHAUST PIPE. >

  9. Install the center exhaust pipe. (TURBO model) < Ref. to INSTALLATION , CENTER EXHAUST PIPE. >
  10. Lower the vehicle.
  11. Install the inhibitor switch connector from stay.
  12. Connect the inhibitor switch connector.
    Fig 5: Identifying Inhibitor Switch Connector
    G04990327Courtesy of SUBARU OF AMERICA, INC.
  13. Install the air cleaner case or air intake chamber. (Non-TURBO model)

    < Ref. to INSTALLATION , AIR CLEANER CASE. >

  14. Install the intercooler. (TURBO model)

    < Ref. to INSTALLATION , INTERCOOLER. >

  15. Inspect the inhibitor switch. < Ref. to INSPECTION . >
· About lemon-mirror