lemon-mirror:
Home >> Subaru >> 2006 >> Baja Base, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> Transmission Control Device >> Removal

Transmission Control Device: Removal

  1. Remove the transmission assembly from the vehicle. < Ref. to REMOVAL . >
  2. Extract the torque converter clutch assembly. < Ref. to REMOVAL . >
  3. Remove the input shaft.
  4. Lift-up the lever behind the transmission harness connector and disconnect it from stay.
  5. Disconnect the air breather hoses. < Ref. to REMOVAL . >
  6. Disconnect the inhibitor switch connector from stay.
  7. Wrap the nipple attached to the air breather hose around with a vinyl tape.
  8. Remove pitching stopper bracket.
  9. Remove the inhibitor switch.
    Fig 1: Identifying Inhibitor Switch
    G05002846Courtesy of SUBARU OF AMERICA, INC.
  10. Remove the control valve body assembly. < Ref. to REMOVAL . >
  11. Pull off the straight pin of manual plate.
    Fig 2: Identifying Spring Pin To Manual Plate
    G05002847Courtesy of SUBARU OF AMERICA, INC.
  12. Remove the bolts securing select lever, then remove the select lever, manual plate and parking rod.
    NOTE: Be careful not to damage the lips of the press-fitted oil seal in the case.
    Fig 3: Identifying Range Select Lever, Manual Plate And Parking Rod
    G04990695Courtesy of SUBARU OF AMERICA, INC.
  13. Remove the detention spring.
    Fig 4: Identifying Detent Spring
    G05002849Courtesy of SUBARU OF AMERICA, INC.
· About lemon-mirror