Differential Case Assembly

Install the washer, differential bevel gear and differential bevel pinion in the differential case (RH). Insert the pinion shaft.
Attach the straight pin in the reverse direction.

Fig 1: Attaching Straight Pin
Courtesy of SUBARU OF AMERICA, INC.
Install the washer and differential bevel gear to differential case (LH). Put the differential case (RH) on the case, and then assemble the two cases.
Install the hypoid driven gear and secure by tightening the bolt.
Tightening torque:

62 N.m (6.3 kgf-m, 45.6 ft-lb)

Fig 2: Identifying Hypoid Driven Gear
Courtesy of SUBARU OF AMERICA, INC.

Measurement of backlash (Selection of washer)

Install the SUBARU genuine axle shaft to differential case.
Part No. 38415AA070 Axle shaft
Measure the gear backlash using ST1 and ST2, and then insert ST2 from the access window of the case.
ST1 498247001 MAGNET BASE

ST2 498247100 DIAL GAUGE
NOTE:
- Measure the backlash by placing the differential bevel pinion tooth against two differential bevel gear teeth.
- Fix the differential bevel pinion gear in place with a screwdriver or similar tool when measuring.
Standard:

0.13 - 0.18 mm (0.0051 - 0.0071 in)

Fig 3: Measuring Gear Backlash
Courtesy of SUBARU OF AMERICA, INC.

If the backlash is out of specification, select a washer from the table below.

WASHER THICKNESS

Using the ST, install the taper roller bearing.
ST 398487700 INSTALLER

Fig 4: Identifying Taper Roller Bearing
Courtesy of SUBARU OF AMERICA, INC.