lemon-mirror:
Home >> Subaru >> 2006 >> Outback R >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Engine (Diagnostics) (H6DO) >> Compulsory Valve Operation Check Mode >> Operation

Compulsory Valve Operation Check Mode: Operation

  1. Prepare the Subaru Select Monitor kit. < Ref. to PREPARATION TOOL , General Description. >
    Fig 1: Identifying Subaru Select Monitor Kit
    G04998013
  2. Connect the diagnosis cable to the Subaru Select Monitor.
  3. Insert the cartridge to the Subaru Select Monitor. < Ref. to PREPARATION TOOL , General Description. >
    Fig 2: Inserting Cartridge Into Subaru Select Monitor
    G04998014
  4. Connect the test mode connector (A) located under the glove box.
    Fig 3: Identifying Test Mode Connector
    G05019002
  5. Connect the Subaru Select Monitor to data link connector located in the lower portion of the instrument panel (on the driver's side).
    Fig 4: Locating Data Link Connector
    G05017015
    CAUTION: Do not connect any scan tools except Subaru Select Monitor or general scan tool.
  6. Turn the ignition switch to ON (engine OFF) and Subaru Select Monitor switch to ON.
    Fig 5: Identifying Power Switch
    G04989876
  7. On the «Main Menu» display screen, select {Each System Check} and press the [YES] key.
  8. On the «System Selection Menu» display screen, select {Engine Control System} and press the [YES] key.
  9. Press the [YES] key after the information of engine type has been displayed.
  10. On the «Engine Diagnosis» display screen, select the {System Operation Check Mode} and press the [YES] key.
  11. On the «System Operation Check Mode» display screen, select the {Actuator ON/OFF Operation} and press the [YES] key.
  12. Select the desired compulsory actuator on the «Actuator ON/OFF Operation» display screen and press the [YES] key.
  13. Pressing the [NO] key completes the compulsory valve operation check mode. The display will then return to the «Actuator ON/OFF Operation» screen.
    • A list of the support data is shown in the following table.
      LIST OF SUPPORT DATA

      Description Display
      Compulsory fuel pump relay operation check Fuel Pump
      Compulsory radiator fan relay operation check Radiator Fan Relay
      Compulsory air conditioning relay operation check A/C Compressor Relay
      Compulsory purge control solenoid valve operation check CPC Solenoid
      Compulsory pressure control solenoid valve operation check PCV Solenoid
      Compulsory drain valve operation check Vent Control Solenoid
NOTE:
  • The following parts will be displayed but not functional.
    DISPLAY REFERENCE

    Display
    EGR Solenoid
    ASV Solenoid
    FICD Solenoid
    Pressure Switching Solenoid 1
    Pressure Switching Solenoid 2
    Wastegate solenoid
    AAI Solenoid
    Exhaust Bypass Valve Control Permit Flag
    Secondary Air Combination Valve
    Fuel Tank Sensor Control Valve
  • For detailed operation procedure, refer to the "general scan tool operation manual".
· About lemon-mirror