Operating Cylinder: Installation

WARNING: This page is about a different variant/trim than selected.

Install in the reverse order of removal.
NOTE: Before installing the operating cylinder, apply grease (SUNLIGHT 2: Part No. 003602010) to the contact point of the release lever and operating cylinder.

Tightening torque:

T1: 18 N.m (1.8 kgf-m, 13.0 ft-lb)

T2: 37 N.m (3.8 kgf-m, 27.5 ft-lb)

Fig 1: Identifying Clutch Hose And Operating Cylinder
After bleeding air from the operating cylinder, ensure that the clutch operates properly.
< Ref. to CLUTCH FLUID AIR BLEEDING . >