Extension Case: Installation

Apply Vaseline to the contact surface, and attach the selected thrust needle bearing to the end surface of the reduction drive gear.
NOTE: Install the thrust needle bearing in the correct direction.
Install a new gasket.
Install the extension case to transmission case.
Tighten bolts to secure the extension case.
Tightening torque:

25 N.m (2.5 kgf-m, 18 ft-lb)

Fig 1: Identifying Extension Case
Courtesy of SUBARU OF AMERICA, INC.
Install the rear vehicle speed sensor.
Tightening torque:

7 N.m (0.7 kgf-m, 5.1 ft-lb)

Fig 2: Identifying Rear Vehicle Speed Sensor
Courtesy of SUBARU OF AMERICA, INC.
Install the transmission assembly.
< Ref. to INSTALLATION , Automatic Transmission Assembly. >