lemon-mirror:
Home >> Subaru >> 2006 >> Outback i, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission 4AT >> Front Vehicle Speed Sensor >> Installation

Front Vehicle Speed Sensor: Installation

  1. Pass the harness assembly through the hole in transmission case.
    Fig 1: Identifying Harness Assembly
    G05021842Courtesy of SUBARU OF AMERICA, INC.
  2. Connect the harness connector and transmission ground.

    Tightening torque: 

    8 N.m (0.8 kgf-m, 5.8 ft-lb) 

    Fig 2: Identifying Harness Connector And Transmission Ground
    G05021843Courtesy of SUBARU OF AMERICA, INC.
  3. Apply proper amount of liquid gasket to the entire oil pan mating surface.

    Liquid gasket: 

    THREE BOND 1217B (Part No. K0877YA020) 

    Fig 3: Applying Amount Of Liquid Gasket To Oil Pan Mating Surface
    G05002534Courtesy of SUBARU OF AMERICA, INC.
  4. Apply an adequate amount of liquid gasket to the three holes excluding the screw holes of the transmission case.

    Liquid gasket: 

    THREE BOND 1217B (Part No. K0877YA020) 

    Fig 4: Locating Oil Pan Tightening Bolts
    G05002555Courtesy of SUBARU OF AMERICA, INC.
  5. Install the oil pan.

    Tightening torque: 

    5 N.m (0.5 kgf-m, 3.6 ft-lb) 

  6. Install the front vehicle speed sensor and torque converter turbine speed sensor.

    Tightening torque: 

    7 N.m (0.7 kgf-m, 5.1 ft-lb) 

  7. Connect the connector to the rear vehicle speed sensor.
  8. Install the oil cooler pipe.
    NOTE: Use a new copper washer.

    Tightening torque: 

    T1:25 N.m (2.5 kgf-m, 18 ft-lb) 

    T2: 40 N.m (4.1 kgf-m, 29.5 ft-lb) 

    T3:44 N.m (4.5 kgf-m, 32.5 ft-lb) 

    Fig 5: Connecting Connector To Rear Vehicle Speed Sensor
    G04994105Courtesy of SUBARU OF AMERICA, INC.
  9. Install the transmission rear crossmember bolt.

    Tightening torque: 

    75 N.m (7.6 kgf-m, 55 ft-lb) 

  10. Install the propeller shaft. < Ref. to INSTALLATION , Propeller Shaft. >
  11. Install the shield cover.
  12. Install the front, center and rear exhaust pipes, and the muffler.

    < Ref. to INSTALLATION , Front Exhaust Pipe. > < Ref. to INSTALLATION , Rear Exhaust Pipe. > < Ref. to INSTALLATION , Muffler. >

  13. Lower the vehicle.
  14. Install the transmission connector to the stay.
  15. Install the pitching stopper. < Ref. to INSTALLATION , Transmission Mounting System. >
  16. Install the air intake chamber.

    < Ref. to INSTALLATION , Air Intake Chamber. >

  17. Fill with the same amount of ATF as drained.
  18. Bleed the air of control valve.

    < Ref. to AIR BLEEDING OF CONTROL VALVE . >

  19. Inspect the level of ATF. < Ref. to AUTOMATIC TRANSMISSION FLUID . >
  20. Execute the learning control promotion. < Ref. to FACILITATION OF LEARNING CONTROL , OPERATION, Subaru Select Monitor. >
· About lemon-mirror