lemon-mirror:
Home >> Subaru >> 2006 >> Outback i, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission 4AT >> Inhibitor Switch >> Installation

Inhibitor Switch: Installation

  1. Connect the inhibitor switch harness connector to the inhibitor switch.
  2. Install the inhibitor switch to the transmission case.
    Fig 1: Identifying Inhibitor Switch
    G05021831Courtesy of SUBARU OF AMERICA, INC.
  3. Move the range select lever to the neutral position.
  4. Tighten the three inhibitor switch securing bolts using the ST.

    ST 499267300 STOPPER PIN

    Tightening torque: 

    3.5 N.m (0.36 kgf-m, 2.6 ft-lb) 

    Fig 2: Identifying Inhibitor Switch Securing Bolts
    G05021832Courtesy of SUBARU OF AMERICA, INC.
  5. Install the select cable to the range select lever.
  6. Install the plate assembly to the transmission.

    Tightening torque: 

    T: 25 N.m (2.5 kgf-m, 18 ft-lb) 

    Fig 3: Identifying Select Cable
    G05021833Courtesy of SUBARU OF AMERICA, INC.
  7. Install the washer and snap pin to the range select lever.
    Fig 4: Identifying Washer And Snap Pin
    G05021834Courtesy of SUBARU OF AMERICA, INC.
  8. Install the front and center exhaust pipe.

    < Ref. to INSTALLATION , Front Exhaust Pipe. >

  9. Lower the vehicle.
  10. Install the inhibitor switch connector to the stay.
  11. Connect the inhibitor switch connector.
    Fig 5: Identifying Inhibitor Switch Connector
    G05021835Courtesy of SUBARU OF AMERICA, INC.
  12. Install the air intake chamber.

    < Ref. to INSTALLATION , Air Intake Chamber. >

  13. Inspect the inhibitor switch. < Ref. to INSPECTION , Inhibitor Switch. >
· About lemon-mirror