lemon-mirror:
Home >> Subaru >> 2007 >> Impreza Outback Sport, Automatic >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> A/T Control Systems >> Select Cable >> Installation

Select Cable: Installation

  1. Install the select cable to plate assembly.

    Tightening torque: 

    18 N.m (1.8 kgf-m, 13.0 ft-lb) 

  2. Install the select cable to range select lever.
  3. Install the plate assembly to transmission.

    Tightening torque: 

    T: 24.5 N.m (2.5 kgf-m, 18.1 ft-lb) 

    Fig 1: Identifying Select Cable And Plate Assembly
    G05335518Courtesy of SUBARU OF AMERICA, INC.
  4. Install the washer and snap pin to range select lever.
    Fig 2: Identifying Snap Pin, Select Cable And Range Select Lever
    G05335519Courtesy of SUBARU OF AMERICA, INC.
  5. Insert the tip of inner cable into connector hole of the select lever, and affix the outer cable end to the bracket.

    Tightening torque: 

    18 N.m (1.8 kgf-m, 13.0 ft-lb) 

  6. Move the select lever to the "N" range, then adjust the select cable position. <Ref. to ADJUSTMENT , Select Cable .>
  7. Install the front, center and rear exhaust pipes, and the muffler. (SOHC model)

    <Ref. to INSTALLATION , Front Exhaust Pipe .> <Ref. to INSTALLATION , Center Exhaust Pipe .> <Ref. to INSTALLATION , Rear Exhaust Pipe .> <Ref. to INSTALLATION , Muffler .>

  8. Install the center, rear exhaust pipes and the muffler. (DOHC Turbo model)

    <Ref. to INSTALLATION , Center Exhaust Pipe .> <Ref. to INSTALLATION , Rear Exhaust Pipe .> <Ref. to INSTALLATION , Muffler .>

· About lemon-mirror