Compulsory Valve Operation Check Mode: Operation
- Prepare the Subaru Select Monitor kit. <Ref. to PREPARATION TOOL , General Description .>
- Connect the diagnosis cable to the Subaru Select Monitor.
- Connect the test mode connector (A) located under the glove box.
- Connect the Subaru Select Monitor to data link connector located in the lower portion of the instrument panel (on the driver's side).
CAUTION: Do not connect any scan tools except the Subaru Select Monitor or general scan tool.
- Turn the ignition switch to ON (engine OFF) and run the Subaru Select Monitor.
- On the «Main Menu» display screen, select {Each System Check}.
- On the «System Selection Menu» display screen, select {Engine Control System}.
- Select the [OK] after the information of engine type has been displayed.
- On the «Engine Diagnosis» display screen, select the {System Operation Check Mode}.
- On the «System Operation Check Mode» display screen, select the {Actuator ON/OFF Operation}.
- Select the desired compulsory actuator on the «Actuator ON/OFF Operation» display screen.
- Selecting the [NO] completes the compulsory valve operation check mode. The display will then return to the «Actuator ON/OFF Operation» screen.
- A list of the support data is shown in the following table.SUPPORT DATA CHART
Contents Display Compulsory fuel pump relay operation check Fuel Pump Compulsory radiator fan relay operation check Radiator Fan Relay Compulsory air conditioning relay operation check A/C Compressor Relay Compulsory purge control solenoid valve operation check CPC Solenoid Compulsory wastegate control solenoid valve operation check Wastegate control Solenoid Compulsory pressure control solenoid valve operation check PCV solenoid Compulsory drain valve operation check Vent Control Solenoid