lemon-mirror:
Home >> Subaru >> 2008 >> Outback Base, Automatic >> Repair and Diagnosis >> General Information >> OBD-II Drive Cycles >> Drive Cycles >> Drive Cycle F

Drive Cycle F

  1. Check that the engine coolant temperature at engine start is less than 30°C (86°F).
  2. Start the engine, and warm it up until engine coolant temperature increases over 95°C (203°F).
  3. Idle the engine for more than 10 minutes in the condition of step  2.
    NOTE: Do not disconnect the terminal of battery during diagnosis. (Data will be cleared by disconnecting the battery terminals.)

This drive cycle covers air temperature sensor.

· About lemon-mirror