Extension Case: Installation

Apply vaseline to the contact surface, and attach the selected thrust needle bearing to the end surface of the reduction drive gear.
NOTE: Install the thrust needle bearing in the correct direction.
Install a new gasket.
Install the extension case to transmission case.
Tighten bolts to secure the extension case.
Tightening torque:

25 N.m (2.5 kgf-m, 18.4 ft-lb)

Fig 1: Identifying Transmission Case And Extension Case Section
Courtesy of SUBARU OF AMERICA, INC.
Install the rear vehicle speed sensor.
Tightening torque:

7 N.m (0.7 kgf-m, 5.1 ft-lb)
- MP-T model
  
  Fig 2: Identifying Rear Vehicle Speed Sensor - MP-T Model
  Courtesy of SUBARU OF AMERICA, INC.
- VTD model
  
  Fig 3: Identifying Rear Vehicle Speed Sensor - VTD Model
  Courtesy of SUBARU OF AMERICA, INC.
Install the transmission assembly. < Ref. to INSTALLATION , Automatic Transmission Assembly. >