lemon-mirror:
Home >> Subaru >> 2008 >> Tribeca Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Engine (Diagnostics) (H6DO) >> Compulsory Valve Operation Check Mode >> Operation

Compulsory Valve Operation Check Mode: Operation

  1. Prepare the Subaru Select Monitor kit. <Ref. to PREPARATION TOOL , General Description.>
    Fig 1: Identifying Subaru Select Monitor
    G05658482Courtesy of SUBARU OF AMERICA, INC.
  2. Prepare the personal computer which has been installed the Subaru Select Monitor.
  3. Connect the USB cable between SDI (Subaru Diagnosis Interface) and USB port on the personal computer (dedicated port for the Subaru Select Monitor).
    NOTE: The dedicated port for the Subaru Select Monitor means the USB port which was used to install the Subaru Select Monitor.
  4. Connect the diagnosis cable to the SDI.
  5. Connect the delivery (test) mode connector (A) located under the glove box.
    Fig 2: Connecting Delivery (Test) Mode Connector Under Glove Box
    G05346100Courtesy of SUBARU OF AMERICA, INC.
  6. Connect SDI to data link connector located in the lower portion of the instrument panel (on the driver's side).
    Fig 3: Locating Lower Portion Of Instrument Panel Data Link Connector (On Driver Side)
    G05031666Courtesy of SUBARU OF AMERICA, INC.
    CAUTION: Do not connect the scan tools except for Subaru Select Monitor and general scan tool.
  7. Start up the personal computer.
  8. Turn the ignition switch to ON (engine OFF), and run the "PC application for Subaru Select Monitor".
  9. On the « Main Menu » display screen, select the {Each System Check}.
  10. On the « System Selection Menu » display screen, select the {Engine Control System}.
  11. Click the [OK] button after the information of engine type has been displayed.
  12. On the « Engine Diagnosis » display screen, select the {System Operation Check Mode}.
  13. On the « System operation check mode » display screen, select the {Actuator ON/OFF Operation}.
  14. Select the desired actuator on the « Actuator ON/OFF Operation » display screen and click the [Next] button.
  15. Clicking the [End] button completes the compulsory valve operation check mode. The display will then return to the « Actuator ON/OFF Operation » screen.
    • A list of the support data is shown in the following table.
    SUPPORT DATA DISPLAY CHART

    Description Display
    Compulsory fuel pump relay operation check Fuel Pump
    Compulsory radiator fan relay operation check Radiator Fan Relay
    Compulsory air conditioning relay operation check A/C Compressor Relay
    Compulsory purge control solenoid valve operation check CPC Solenoid
    Compulsory drain valve operation check Vent Control Solenoid
    NOTE:
    • The following parts will be displayed but not functional.
    DISPLAY CHART

    Display
    EGR Solenoid
    ASV Solenoid
    FICD Solenoid
    Pressure Switching Solenoid 1
    Pressure Switching Solenoid 2
    Wastegate Control Solenoid
    AAI Solenoid
    Exhaust Bypass Valve Control Permit Flag
    PCV Solenoid
    Fuel Tank Sensor Control Valve
    Secondary Air Combination Valve 1
    NOTE:
    • For detailed operation procedure, refer to the "PC application for Subaru Select Monitor".
· About lemon-mirror