lemon-mirror:
Home >> Subaru >> 2008 >> Tribeca Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission Control Systems >> Select Cable >> Removal

Select Cable: Removal

  1. Set the vehicle on a lift.
  2. Shift the select lever to "N" range.
  3. Disconnect the ground cable from the battery.
  4. Lift up the vehicle.
  5. Remove the front, center and rear exhaust pipes and muffler. < Ref. to REMOVAL , Front Exhaust Pipe . > < Ref. to REMOVAL , Rear Exhaust Pipe . > < Ref. to REMOVAL , Muffler . >
  6. Remove the heat shield cover.
  7. Remove the snap pin and washer from range select lever.
    Fig 1: Removing Snap Pin And Washer From Range Select Lever
    G05664319Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the plate assembly from the transmission case.
    Fig 2: Removing Plate Assembly From Transmission Case
    G05664320Courtesy of SUBARU OF AMERICA, INC.
  9. Disconnect the cable from arm assembly.
    Fig 3: Disconnecting Cable From Arm Assembly
    G05664321Courtesy of SUBARU OF AMERICA, INC.
  10. Raise the pawl of clamp to remove the cable from bracket.
    Fig 4: Identifying Claw
    G05664322Courtesy of SUBARU OF AMERICA, INC.
  11. Remove the select cable from plate assembly.
· About lemon-mirror