Simple Learning

NOTE: Simple learning is learning performed with the vehicle lifted, without actually running the vehicle.

CAUTION: Do not turn the power of the Subaru Select Monitor to OFF or disconnect the data link connector during the operation.

Select {Learning and inspection mode related to AT} on the «Transmission Diagnosis» display screen of Subaru Select Monitor.
Select {AT learning mode} on the «Learning and inspection mode related to AT» display screen of Subaru Select Monitor.
Perform the procedures according to the message displayed on the Subaru Select Monitor.
NOTE: During AT learning in progress, SPORT indicator light in the combination meter starts flashing at 2 Hz and the learning operation starts. The following message is displayed on the screen when the SPORT indicator light turns off.

"AT learning normally ended." is displayed, simple AT learning is completed.

NOTE:

If communication error occurs during learning, retry "AT learning mode" from the beginning.
If "Execute AT learning again after fixing troubles of the vehicle" is displayed during learning, select [OK] to display the List of Diagnostics Trouble Code. Retry "AT learning mode" from the beginning after repairing the DTC detecting portion.

If "AT learning ended abnormally." is displayed, retry "AT learning mode" from the beginning.

DIAGNOSTICS TROUBLE CODE CHART

Message	Primary cause of abnormal end
"AT learning ended abnormally."	Fault is detected during AT learning. The accelerator pedal is depressed during AT learning. Operation which is not directed is performed during AT learning. The brake pedal is not depressed fully. The parking brake is not applied fully. Abnormal idle rise occurs. Other similar causes are probable.

For details concerning the operation procedure, refer to the PC application help for Subaru Select Monitor.