Control Valve Body: Installation

Check the control valve body for dust and other foreign matter.
Temporarily tighten the control valve body to the transmission.
Install the oil cooler pipe.
Tightening torque:

8 N.m (0.8 kgf-m, 5.9 ft-lb)

Fig 1: Identifying Oil Cooler Pipe
Courtesy of SUBARU OF AMERICA, INC.
Tighten the bolts equally.
Tightening torque:

8 N.m (0.8 kgf-m, 5.9 ft-lb)

Fig 2: Identifying Transmission Case Ground Bolt
Courtesy of SUBARU OF AMERICA, INC.
Connect the control valve connector.

Fig 3: Identifying Control Valve Connector
Courtesy of SUBARU OF AMERICA, INC.
Attach the magnet at the specified position of the oil pan.

Fig 4: Identifying Oil Pan Magnet
Courtesy of SUBARU OF AMERICA, INC.
Apply proper amount of liquid gasket to the entire oil pan mating surface.
Liquid gasket:

THREE BOND 1217B (Part No. K0877YA020) or equivalent

Fig 5: Applying Proper Amount Of Liquid Gasket To Entire Oil Pan Mating Surface
Courtesy of SUBARU OF AMERICA, INC.
Fill the 3 holes aside from the bolt holes in the transmission case, with liquid gasket.
Liquid gasket:

THREE BOND 1217B (Part No. K0877YA020) or equivalent

Fig 6: Locating Transmission Case Excluding Bolt Holes
Courtesy of SUBARU OF AMERICA, INC.
Install the oil pan by equally tightening the bolts.
Tightening torque:

5 N.m (0.5 kgf-m, 3.7 ft-lb)
Fill ATF from the oil charger pipe.
Recommended fluid:

Refer to HYDRAULIC CONTROL AND LUBRICATION , SPECIFICATION, General Description.

Capacity:

Fill with the same amount of ATF as drained .
Bleed the air of control valve. Refer to AIR BLEEDING OF CONTROL VALVE .
Check the ATF level.
Refer to AUTOMATIC TRANSMISSION FLUID .
Execute the learning control promotion. Refer to PROCEDURE , Learning Control.