Front Vehicle Speed Sensor: Installation

Pass the transmission harness assembly through the hole of the transmission case.

Fig 1: Identifying Transmission Harness Assembly
Courtesy of SUBARU OF AMERICA, INC.
Connect the control valve connector and transmission ground.
Tightening torque:

8 N.m (0.8 kgf-m, 5.9 ft-lb)

Fig 2: Identifying Control Valve Connector And Transmission Ground
Courtesy of SUBARU OF AMERICA, INC.
Apply proper amount of liquid gasket to the entire oil pan mating surface.
Liquid gasket:

THREE BOND 1217B (Part No. K0877YA020) or equivalent

Fig 3: Applying Proper Amount Of Liquid Gasket To Entire Oil Pan Mating Surface
Courtesy of SUBARU OF AMERICA, INC.
Fill the 3 locations of the transmission case excluding the bolt holes with an ample amount of liquid gasket.
Liquid gasket:

THREE BOND 1217B (Part No. K0877YA020) or equivalent

Fig 4: Locating Transmission Case Excluding Bolt Holes
Courtesy of SUBARU OF AMERICA, INC.
Install the oil pan by equally tightening the bolts.
Tightening torque:

5 N.m (0.5 kgf-m, 3.7 ft-lb)
Install the front vehicle speed sensor and torque converter turbine speed sensor.
Tightening torque:

7 N.m (0.7 kgf-m, 5.2 ft-lb)
Connect the connector to the rear vehicle speed sensor.
Install the ATF inlet and outlet pipes.
NOTE: Use a new copper washer.

Tightening torque:

T1: 25 N.m (2.5 kgf-m, 18.4 ft-lb)

T2: 40 N.m (4.1 kgf-m, 29.5 ft-lb)

T3: 45 N.m (4.6 kgf-m, 33.2 ft-lb)

Fig 5: Identifying ATF Inlet And Outlet Pipes
Courtesy of SUBARU OF AMERICA, INC.
Install the transmission rear crossmember bolt.
Tightening torque:

70 N.m (7.1 kgf-m, 51.6 ft-lb)
Install the propeller shaft. Refer to INSTALLATION , Propeller Shaft.
Install the heat shield cover.

Fig 6: Identifying Heat Shield Cover
Courtesy of SUBARU OF AMERICA, INC.
Install the front, center and rear exhaust pipes, and the muffler. (Non-turbo model)
Refer to INSTALLATION , Front Exhaust Pipe. Refer to INSTALLATION , Rear Exhaust Pipe. Refer to INSTALLATION , Muffler.
Install the center, rear exhaust pipes and the muffler. (Turbo model)
Refer to INSTALLATION , Center Exhaust Pipe. Refer to INSTALLATION , Rear Exhaust Pipe. Refer to INSTALLATION , Muffler.
Lower the vehicle.
Install the transmission harness connector to the stay.
Install the pitching stopper. Refer to INSTALLATION , Transmission Mounting System.
Install the air intake chamber. (Non-turbo model)
Refer to INSTALLATION , Air Intake Chamber.
Install the intercooler. (Turbo model)
Refer to INSTALLATION , Intercooler.
Fill with the same amount of ATF as drained.
Bleed the air of control valve.
Refer to AIR BLEEDING OF CONTROL VALVE .
Inspect the level of ATF. Refer to AUTOMATIC TRANSMISSION FLUID .
Execute the learning control promotion. Refer to PROCEDURE , Learning Control.