lemon-mirror:
Home >> Subaru >> 2009 >> Outback R Limited >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission 5AT >> Rear Vehicle Speed Sensor >> Installation

Rear Vehicle Speed Sensor: Installation

  1. Install the rear vehicle speed sensor.

    Tightening torque: 7 N.m (0.7 kgf-m, 5.2 ft-lb) 

    Fig 1: Identifying Rear Vehicle Speed Sensor
    G05668784Courtesy of SUBARU OF AMERICA, INC.
  2. Connect the rear vehicle speed sensor connector.
    Fig 2: Identifying Rear Vehicle Speed Sensor Connector
    G05668772Courtesy of SUBARU OF AMERICA, INC.
  3. Install the transmission rear crossmember bolt.

    Tightening torque: 75 N.m (7.6 kgf-m, 55.3 ft-lb) 

  4. Install the propeller shaft. Refer to INSTALLATION , Propeller Shaft.
  5. Install the heat shield cover.
    Fig 3: Identifying Heat Shield Cover
    G05019661Courtesy of SUBARU OF AMERICA, INC.
  6. Install the center, rear exhaust pipes and the muffler. (Turbo model) Refer to INSTALLATION , Center Exhaust Pipe. Refer to INSTALLATION , Rear Exhaust Pipe. Refer to INSTALLATION , Muffler.
  7. Install the rear exhaust pipe and muffler. (Non-turbo model) Refer to INSTALLATION , Rear Exhaust Pipe. Refer to INSTALLATION , Muffler.
  8. Lower the vehicle.
  9. Pour ATF from the oil charge pipe. Refer to AUTOMATIC TRANSMISSION FLUID .
  10. Check the level and leaks of ATF. Refer to INSPECTION , Automatic Transmission Fluid.
· About lemon-mirror