lemon-mirror:
Home >> Subaru >> 2009 >> Tribeca Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Engine (Diagnostics) (H6DO) >> Compulsory Valve Operation Check Mode >> Operation

Compulsory Valve Operation Check Mode: Operation

  1. Prepare the Subaru Select Monitor kit. Ref. to PREPARATION TOOL , General Description.
    Fig 1: Identifying Subaru Select Monitor Kit
    G05658482Courtesy of SUBARU OF AMERICA, INC.
  2. Prepare PC with Subaru Select Monitor installed.
  3. Connect the SDI (Subaru Diagnostic Interface) to the PC USB port (exclusively for Subaru Select Monitor) using a USB cable.
    NOTE: The dedicated port for the Subaru Select Monitor means the USB port which was used to install the Subaru Select Monitor.
  4. Connect the diagnosis cable to SDI.
  5. Connect the delivery (test) mode connector (A) located under the glove box.
    Fig 2: Identifying Test Mode Connector Location
    G05346100Courtesy of SUBARU OF AMERICA, INC.
  6. Connect the SDI to data link connector located in the lower portion of the instrument panel (on the driver's side).
    Fig 3: Connecting SDI To Data Link Connector
    G05031666Courtesy of SUBARU OF AMERICA, INC.
    CAUTION: Do not connect the scan tools except for Subaru Select Monitor and general scan tool.
  7. Start up the PC.
  8. Turn the ignition switch to ON (engine OFF) and run the "PC application for Subaru Select Monitor".
  9. On the «Main Menu», select {Each System Check}.
  10. On the «System Selection Menu», select {Engine Control System}.
  11. Click the [OK] key after the information regarding engine type has been displayed.
  12. Select {System Operation Check Mode} on the «Engine Diagnosis» display screen.
  13. On the «System Operation Check Mode» display screen, select the {Actuator ON/OFF Operation}.
  14. Select the desired actuator on the «Actuator ON/OFF Operation» display screen and click the [Next] button.
  15. Clicking the [Quit] button completes the compulsory valve operation check mode. The display will then return to the «Actuator ON/OFF Operation» screen.
    • A list of the support data is shown in the following table.
    SUPPORT DATA REFERENCE

    Description Display
    Compulsory fuel pump relay operation check Fuel Pump Relay
    Compulsory radiator fan relay operation check Radiator Fan Relay
    Compulsory air conditioning relay operation check A/C Compressor Relay
    Compulsory purge control solenoid valve operation check CPC Solenoid Valve
    Compulsory drain valve operation check Vent. Solenoid Valve
    NOTE:
    • The following parts will be displayed but not functional.
    OPERATION CHART

    Display
    EGR Solenoid Valve
    ASV Solenoid Valve
    FICD Solenoid
    Pressure Switching Sol.1
    Pressure Switching Sol.2
    Turbocharger Wastegate Solenoid
    AAI Solenoid Valve
    EXH. Bypass Control Permit Flag
    PCV Solenoid Valve
    Tank Sensor Cntl Valve
    Secondary Air Combi Valve 1
· About lemon-mirror