lemon-mirror:
Home >> Subaru >> 2011 >> Outback R >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Security And Locks) >> Ignition Key Lock >> Inspection

Ignition Key Lock: Inspection

WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ignition switch connector.
  2. Measure the resistance between ignition switch terminals.

    Preparation tool: Circuit tester 

    Fig 1: Identifying Ignition Switch Connector Terminals
    G06653928Courtesy of SUBARU OF AMERICA, INC.
    Terminal No. Inspection Conditions Specification
    - LOCK -
    3 - 5 ACC Less than 1 Ω
    3 - 1, 4
    3 - 5    		 ON Less than 1 Ω
    3 - 2, 6
    3 - 1, 4    		 ST Less than 1 Ω
  3. Replace the ignition switch if the inspection result is not within the standard value.
· About lemon-mirror