Power Window Control Switch: Inspection: Sub-Switch

WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Remove the sub switch.

Check the resistance between sub switch terminals.

Fig 1: Checking Resistance Between Sub Switch Terminals

Courtesy of SUBARU OF AMERICA, INC.

	Terminal No.	Inspection conditions	Specification
Passenger's seat, rear	4 - 5 6 - 7	UP	Less than 1 Ω
	7 - 4 8 - 4	OFF	1 MΩ or more
	5 - 8 6 - 7	OFF	Less than 1 Ω
	4 - 6 5 - 8	DOWN	Less than 1 Ω

Replace the sub switch if the inspection result is not within the standard value.