lemon-mirror:
Home >> Subaru >> 2011 >> Outback R >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Continuously Variable Transmission) >> Transmission Control Device >> Installation

Transmission Control Device: Installation

WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the detent spring to the transmission case.

    Tightening torque: 

    7 N.m (0.7 kgf-m, 5.2 ft-lb) 

    Fig 1: Identifying Detent Spring (View 2 Of 2)
    G06654618Courtesy of SUBARU OF AMERICA, INC.
  2. Install the manual plate, parking rod, range select lever and bolt.

    Tightening torque: 

    7 N.m (0.7 kgf-m, 5.2 ft-lb) 

    Fig 2: Identifying Range Select Lever, Manual Plate, Parking Rod And Bolt
    G07913564Courtesy of SUBARU OF AMERICA, INC.
  3. Install the spring pin.
    NOTE: Use new spring pin.
    Fig 3: Identifying Spring Pin
    G06654616Courtesy of SUBARU OF AMERICA, INC.
  4. Install the inhibitor switch. Refer to , INHIBITOR SWITCH .
  5. Adjust the inhibitor switch. Refer to , INHIBITOR SWITCH .
  6. Install the control valve body and oil pan. Refer to , INSTALLATION , Control Valve Body.
  7. Install the transmission assembly to the vehicle. Refer to , INSTALLATION , Automatic Transmission Assembly.
· About lemon-mirror