Brake Pipe: Installation
WARNING: This page is about a different car, the 2012 Subaru Outback and 2012 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Airbag system wiring harness and connectors are colored yellow. Do not use electrical test equipment on these circuits.
- Be careful not to damage the airbag system wiring harness when servicing the center brake pipe.
- When installing the brake pipe, do not bend.
- After installing the brake pipe and hose, perform air bleed.
- After installing the brake hoses, make sure that they do not contact the tires or suspension assembly, etc.
NOTE:
The airbag system wiring harness is routed near the center brake pipe.
Tightening torque:
Front brake pipes & hoses: Refer to , FRONT BRAKE PIPES AND HOSES , COMPONENT, General Description.
Center & rear brake pipes and hoses: Refer to , CENTER AND REAR BRAKE PIPES AND HOSES , COMPONENT, General Description.