Extension Case: Installation

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.

Attach the selected reduction driven gear shim to end surface of reduction driven gear with vaseline. Refer to ADJUSTMENT , Reduction Driven Gear.
Install the extension case.
NOTE: Use a new gasket.

Tightening torque:

25 N.m (2.5 kgf-m, 18.4 ft-lb)

Fig 1: Identifying Extension Case
Courtesy of SUBARU OF AMERICA, INC.
Install the rear vehicle speed sensor.
Tightening torque:

7 N.m (0.7 kgf-m, 5.2 ft-lb)

Fig 2: Identifying Rear Vehicle Speed Sensor
Courtesy of SUBARU OF AMERICA, INC.
Connect the rear vehicle speed sensor connector.

Fig 3: Identifying Rear Vehicle Speed Sensor Connector
Courtesy of SUBARU OF AMERICA, INC.
Install the transmission assembly. Refer to INSTALLATION , Automatic Transmission Assembly.