lemon-mirror:
Home >> Subaru >> 2012 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Automatic Transmission) >> Front Differential Assembly >> Installation

Front Differential Assembly: Installation

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.
  1. When installing the front differential assembly to case, be careful not to damage the inside of case (particularly, the differential side retainer mating surface).
    Fig 1: Identifying Front Differential Assembly
    G06343026Courtesy of SUBARU OF AMERICA, INC.
  2. Install the O-ring to left and right side retainer.
  3. Using the ST, install the side retainer. Refer to ADJUSTMENT , Front Differential Assembly.

    ST 18630AA010 WRENCH COMPL RETAINER

  4. Adjust the backlash of the front differential. Refer to ADJUSTMENT , Front Differential Assembly.
  5. Install the lock plate.

    Tightening torque: 

    25 N.m (2.5 kgf-m, 18.4 ft-lb) 

    Fig 2: Identifying Lock Plate
    G06343027Courtesy of SUBARU OF AMERICA, INC.
  6. Install the converter case to the transmission case. Refer to INSTALLATION , Converter Case.
  7. Install the transmission harness connector to the stay.
  8. Install the ATF cooler pipe. Refer to INSTALLATION , ATF Cooler Pipe and Hose.
  9. Install the oil charge pipe together with an O-ring. Refer to INSTALLATION , Oil Charge Pipe.
  10. Install the torque converter assembly. Refer to INSTALLATION , Torque Converter Assembly.
  11. Install the transmission assembly to the vehicle. Refer to INSTALLATION , Automatic Transmission Assembly.
· About lemon-mirror