Front Stabilizer: Installation

WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal.

CAUTION:

Be sure to use a new flange nut.
Install so that the paint mark on the stabilizer is on the left side of the vehicle.
Install the stabilizer bushing (front crossmember side) while aligning it with the paint mark on stabilizer.

Tightening torque:

Stabilizer link:

60 N.m (6.1 kgf-m, 44.3 ft-lb)

Stabilizer clamp:

25 N.m (2.5 kgf-m, 18.1 ft-lb)