Brake Pipe: Installation
WARNING: This page is about a different car, the 2011 Subaru Tribeca. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The airbag system wiring harness is routed near the center brake pipe.
CAUTION:
- All airbag system wiring harness and connectors are colored yellow. Do not use the electrical test equipment on these circuits.
- Be careful not to damage the airbag system wiring harness when servicing the center brake pipe.
- When installing the brake pipe, do not bend.
- After installing the brake pipe and hose, perform air bleed.
- After installing the brake hoses, make sure that they do not contact the tires or suspension assembly, etc.
Brake pipe tightening torque:
15 N.m (1.5 kgf-m, 10.8 ft-lb)