Upper Arm: Installation
CAUTION:
- Use a new self-locking nut.
- Always tighten the bushing when the arm is positioned in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.
- Before installation, inspect the following items and replace any faulty part with a new one.
- Visually check the upper arm for damage and deformation.
- Visually check the bushing for abnormal cracks, fatigue or damage.
- Visually check the dust cover on the ball joint for abnormal cracks, fatigue or damage.
- Install each part in the reverse order of removal.
- Inspect the wheel alignment and adjust if necessary.
Tightening torque:
Upper arm - rear sub frame: 80 N.m (8.16 kgf-m, 59.0 ft-lb)
Upper arm - rear housing: 80 N.m (8.16 kgf-m, 59.0 ft-lb)
Rear ABS vehicle speed sensor bracket: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb)