lemon-mirror:
Home >> Subaru >> 2012 >> Outback Base, Standard Trans >> Repair and Diagnosis >> Transmission >> Manual Trans >> Manual Transmission And Differential >> Front Differential Assembly >> Installation

Front Differential Assembly: Installation

  1. Install the differential side retainers using ST.

    ST 18658AA020 WRENCH COMPL RETAINER

  2. Install the bearing outer race to the transmission case.
  3. Install the front differential assembly.
    NOTE: Be careful not to fold the sealing lip of oil seal.
    Fig 1: Installing Front Differential Assembly
    G05003046Courtesy of SUBARU OF AMERICA, INC.
  4. Install the main shaft assembly for single-range. Refer to Main Shaft Assembly for Single-Range  .
  5. Install the drive pinion shaft assembly. Refer to Drive Pinion Shaft Assembly  .
  6. Install the transmission case. Refer to Transmission Case  .
  7. Install the transfer case together with the extension case assembly. Refer to Transfer Case and Extension Case Assembly  .
  8. Install the manual transmission assembly to the vehicle. Refer to Manual Transmission Assembly  .
· About lemon-mirror