lemon-mirror:
Home >> Subaru >> 2012 >> Tribeca Limited >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - Diagnostics >> Subaru Select Monitor >> Operation >> Read Current Data

Read Current Data

  1. On the «Main Menu» display screen, select the {Each System Check}.
  2. On the «System Selection Menu», select {Transmission Control System}.
  3. After transmission type information pops up, select [OK].
  4. On the «Transmission Diagnosis» screen, select {Current Data Display & Save}.
  5. On «Current Data Display & Save» display, select {Normal sampling}.
  6. Using the scroll key, scroll the display screen up or down until the desired data is shown.
    • A list of the support data is shown in the following table.
    SUPPORT DATA REFERENCE

    Item Display Unit of measure
    Engine speed signal Engine Speed RPM
    Battery voltage Battery Voltage V
    Accelerator pedal position sensor Accel. Opening Angle %
    Front vehicle speed sensor signal Front Wheel Speed km/h
    Gear position Gear Position -
    Turbine speed sensor signal Turbine Revolution Speed RPM
    Rear vehicle speed sensor signal Rear Wheel Speed km/h
    G sensor Lateral G Sensor V
    ATF temperature sensor signal ATF Temp. °C
    Turbine speed sensor 1 signal AT Turbine Speed 1 RPM
    Turbine speed sensor 2 signal AT Turbine Speed 2 RPM
    High & low reverse clutch solenoid indicator current H&LR/C Solenoid Current A
    Direct clutch solenoid set current D/C Solenoid Current A
    Front brake solenoid set current F/B Solenoid Current A
    Input clutch solenoid set current I/C Solenoid Current A
    Line pressure solenoid set current P/L Solenoid Current A
    Lock-up solenoid set current L/U Solenoid Current A
    Transfer solenoid set current AWD Sol. Current A
    High & low reverse clutch solenoid pressure H&LR/C Solenoid Pressure kPa
    Direct clutch solenoid pressure D/C Solenoid Pressure kPa
    Front brake solenoid pressure F/B Solenoid Pressure kPa
    Input clutch solenoid pressure I/C Solenoid Pressure kPa
    Line pressure solenoid pressure P/L Solenoid Pressure kPa
    Lock-up solenoid pressure L/U Solenoid Pressure kPa
    Transfer solenoid pressure AWD Solenoid Pressure kPa
    Forward brake set current Fwd/B solenoid current A
    Forward brake solenoid pressure Fwd/B solenoid target pressure kPa
    Ignition switch Ignition Switch ON Input or OFF Input
    Manual mode switch signal Tiptronic Mode Switch ON or OFF
    Cruise control set signal Cruise Control Signal ON or OFF
    Down shift signal Down Switch ON or OFF
    Stop light switch signal Stop Light Switch ON or OFF
    Up shift signal Up Switch ON or OFF
    Drive range signal D Range Signal ON or OFF
    Reverse range signal R Range Signal ON or OFF
    Diagnosis light output signal Diagnosis Lamp ON or OFF
    ATF temperature light signal ATF Temperature Lamp ON or OFF
    Parking range signal P Range ON or OFF
    P/N range output signal P/N Signal ON or OFF
    Neutral range signal N Range ON or OFF
    Inhibitor switch 1 input signal Inhibitor SW 1 High or Low
    Inhibitor switch 2 input signal Inhibitor SW 2 High or Low
    Inhibitor switch 3 input signal Inhibitor SW 3 High or Low
    Inhibitor switch 4 input signal Inhibitor SW 4 High or Low
    Back-up light relay output signal Back Lamp Relay ON or OFF
    High & low reverse clutch fluid pressure switch input signal H&LR/C Fluid Pressure ON or OFF
    Direct clutch oil pressure switch input signal D/C Fluid Pressure ON or OFF
    Front brake oil pressure switch input signal F/B Fluid Pressure ON or OFF
    Input clutch oil pressure switch input signal I/C Fluid Pressure ON or OFF
    Forward brake fluid pressure switch input signal Fwd/B hydraulic pressure SW ON or OFF
    AT learning mode AT learning ON or OFF
    NOTE: For details concerning the operation procedure, refer to SUBARU SELECT MONITOR .
· About lemon-mirror