Engine Control Module (ECM): Installation

Install in the reverse order of removal.

CAUTION:

When the ECM of model with immobilizer has been replaced, be sure to perform the registration of immobilizer system. (Refer to "Subaru Select Monitor" operating information.)
When replacing the ECM or bracket, replace both parts with new parts.
After installing the bracket to the ECM, do not separate the bracket.
If the bracket has been installed to the ECM in the wrong direction, replace both parts with new parts.

NOTE: When replacing the ECM, be careful not to use the wrong spec. ECM to avoid any damage on the fuel injection system.

Tightening torque:

7.5 N.m (0.8 kgf-m, 5.5 ft-lb)