Brake Pipe: Installation

WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Be careful of the following items. Failure to do so may cause the airbag system malfunction.
- Yellow connectors and harnesses with yellow tapes around them are the connectors and harnesses for the airbag system. When using a tester on these circuits, follow the cautions of "AIRBAG SYSTEM". <Ref. to CAUTION , General Description.>
- Be careful not to damage the airbag system wiring harness when servicing the electrical parts around the steering column.
Be careful not to damage the airbag system wiring harness when servicing the center brake pipe.
When installing the brake pipe, do not bend.
After installing the brake pipe and hose, perform air bleed.
After installing the brake hoses, make sure that they do not contact the tires or suspension assembly, etc.

NOTE: The airbag system wiring harness is routed near the center brake pipe.

Tightening torque:

Front brake pipes & hoses: <Ref. to FRONT BRAKE PIPES AND HOSES , COMPONENT, General Description.>

Center & rear brake pipes and hoses: <Ref. to CENTER AND REAR BRAKE PIPES AND HOSES , COMPONENT, General Description.>