lemon-mirror:
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 147 (Transmission Control Systems) >> Select Cable >> Removal

Select Cable: Removal

WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Shift the select lever to "N" range.
  2. Disconnect the ground terminal from battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
  3. Lift up the vehicle.
  4. Remove the center exhaust pipe. (2.5 L model) < Ref. to REMOVAL , Center Exhaust Pipe. >
  5. Remove the front exhaust pipe and rear exhaust pipe. (3.6 L model) < Ref. to REMOVAL , Front Exhaust Pipe. > < Ref. to REMOVAL , Rear Exhaust Pipe. >
  6. Remove the center exhaust cover.
    Fig 1: Identifying Center Exhaust Cover
    G10274676Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the snap pin and washer from the shifter arm and remove the select cable from the shifter arm.
    Fig 2: Identifying Snap Pin, Washer, Shifter Arm, Select Cable
    G10312702Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the plate assembly from the transmission case.
    Fig 3: Locating Transmission Case Bolts
    G10312703Courtesy of SUBARU OF AMERICA, INC.
  9. Disconnect the cable from arm assembly.
    Fig 4: Identifying Arm Assembly And Nut
    G10312704Courtesy of SUBARU OF AMERICA, INC.
  10. Raise the claw of clamp to remove the cable from bracket.
    Fig 5: Identifying Cable Bracket Claw
    G10312705Courtesy of SUBARU OF AMERICA, INC.
  11. Remove the select cable from plate assembly.
· About lemon-mirror