Outer Mirror Assembly: Disassembly
CAUTION:
- When removing the mirror - repair, be careful not to damage the back surface of mirror - repair with a flat tip screwdriver.
- When removing the mirror - repair, insert the connector and clip securely.
- Operate the remote control mirror switch to face the mirror - repair upward.
- Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. < Ref. to
BATTERY
, NOTE, Note. >NOTE: For models other than STI model, disconnect the ground terminal from battery sensor.
- Remove the mirror - repair.
- Using a flat tip screwdriver or similar tool, release the engagement shown in the figure, and slide the mirror - repair downward to remove.
- Disconnect connectors. (Model with mirror heater and Subaru Rear Vehicle Detection system)
- Release the claws, and then remove the cover - cap outer mirror lower.
- Release the claws, and then remove the cover - cap outer mirror.CAUTION: Be careful not to apply excessive force when removing the cover - cap outer mirror, as the lower hooks may become damaged.
- Remove the light assembly - side turn mirror. (Model with side turn signal light)
- Remove the screws and pull out the light assembly - side turn mirror to the front of the vehicle.
- Disconnect the connector and remove the light assembly - side turn mirror.