Front Wheel Toe-In

When adjusting the toe-in, adjust it to the following value. Ref. to ADJUSTMENT OF DIFFERENCE BETWEEN RIGHT AND LEFT STEERING ANGLES , ADJUSTMENT, Wheel Alignment.

Toe-in: Adjustment value 

0±2 mm (0±0.08 in) 

1. Check that the left and right wheel steering angles are within specification.
2. Loosen the left and right side steering tie-rod lock nuts (a).
3. Turn the left and right tie-rods by equal amounts until the toe-in is at the specification.
   NOTE: Both the left and right tie-rods are right-hand threaded. To increase toe-in, turn both tie-rods clockwise by equal amount (viewing from the inside of vehicle).
4. Tighten the steering tie-rod lock nut (a).
   Fig 1: Tightening Steering Tie-Rod Lock Nut

   Courtesy of SUBARU OF AMERICA, INC.

   Tightening torque: 

   85 N.m (8.7 kgf-m, 62.7 ft-lb) 

5. Check and correct the tie-rod boot if twisted.