Engine Lubrication System (Except For STI): General Description: Specification
ENGINE LUBRICATION SYSTEM SPECIFICATION
| Lubrication Method | Forced Lubrication | ||||||
| Oil Pump | Pump Type | Trochoid Type | |||||
| Number of Teeth | Inner Rotor | 11 | |||||
| Outer Rotor | 12 | ||||||
| Outer Rotor Diameter X Thickness | mm (in) | 77 x 14 (3.03 x 0.55) | |||||
| Performance (Oil Temperature 120°C (248°F)) |
600 r/min | Discharge Pressure | kPa (kg/cm2 , psi) | 35 (0.4, 5.1) | |||
| Discharge Rate | L (US qt, Imp qt)/min | 7.4 (7.8, 6.5) or more | |||||
| 6, 700 r/min | Discharge Pressure | kPa (kg/cm2 , psi) | 321 (3.3, 46.6) | ||||
| Discharge Rate | L (US qt, Imp qt)/min | 60.2 (63.6, 53.0) or more | |||||
| Relief Valve Working Pressure | kPa (kg/cm2 , psi) | 700 (7.1, 102) | |||||
| Oil Filter(1) | Filter Type | Full-Flow Filter Type | |||||
| Filtration area | cm2 (sq in) | 900 (139.5) | |||||
| By-Pass Valve Opening Pressure | kPa (kg/cm2 , psi) | 160 (1.6, 23.2) | |||||
| Outer diameter x Width | mm (in) | 80 x 65 (3.15 x 2.55) | |||||
| Installation screw specifications | M 20 x 1.5 | ||||||
| Oil Pressure Switch | Type | Immersed Contact Point Type | |||||
| Operating Voltage | 12 V | ||||||
| Warning Light Operating Pressure | kPa (kg/cm2 , psi) | 14.7 (0.1, 2.1) | |||||
| Proof Pressure | kPa (kg/cm2 , psi) | 981 (10, 142.2) | |||||
| Engine Oil | Total Capacity (at overhaul) | L (US qt, Imp qt) | 6.0 (6.3, 5.3) | ||||
| When replacing Engine Oil and Oil Filter | L (US qt, Imp qt) | 5.1 (5.4, 4.5) | |||||
| When replacing Engine Oil only | L (US qt, Imp qt) | 4.9 (5.2, 4.3) | |||||
|
|||||||
Specified Oil:
CAUTION:
- Use 5W-30 (Synthetic Oil).
- It is acceptable to fill an engine with oil of another brand when replacing the oil, but make sure to use the following engine oil specified by Subaru.
NOTE:
The proper viscosity oil helps the engine maintain its ideal temperature, and cranking speed increased by reducing viscosity friction in hot condition.
| ENGINE OIL STANDARD | SAE VISCOSITY NO. | ||
|---|---|---|---|
|
Those with SN "Resource Conserving" logo in case of API standard. |
or |
Those with GF-5 "Starburst Mark" displayed on top of the container in case of ILSAC standard. |
5W-30 (Synthetic Oil) |