Camshaft Position Sensor: Installation: Intake

• RH SIDE 

1. Install the camshaft position sensor with new O-ring.
   NOTE: Apply engine oil to O-ring.

   Tightening torque: 

   6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

2. Connect the connector.
3. Install the air intake duct. Refer to INTAKE (INDUCTION) (H4DO (EXCEPT FOR HEV))>AIR INTAKE DUCT>INSTALLATION .
4. Connect the battery ground terminal. Refer to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .

• LH SIDE 

1. Install the camshaft position sensor with new O-ring.
   NOTE: Apply engine oil to O-ring.

   Tightening torque: 

   6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

2. Connect the connector.
3. Connect the battery ground terminal. Refer to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .