lemon-mirror:
Home >> Subaru >> 2020 >> Legacy Limited >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Infotainment >> Entertainment System >> Data Communication Module >> Removal >> Data Communication Module

Data Communication Module

CAUTION: Before handling the airbag system components, refer to AIRBAG SYSTEM>General Description>CAUTION .
  1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Refer to REPAIR CONTENTS>NOTE>BATTERY .
    NOTE: Release the shift lock and shift the select lever to the "N" position. Refer to CONTROL SYSTEMS>Select Lever>REMOVAL .
  2. Remove the cover LWR driver. Refer to EXTERIOR/INTERIOR TRIM>Instrument Panel Lower Cover>REMOVAL .
  3. Remove the visor assembly. Refer to INSTRUMENTATION/DRIVER INFO>Combination Meter>REMOVAL .
  4. Remove the driver monitoring unit assembly. Refer to INSTRUMENTATION/DRIVER INFO>Driver Monitoring Unit>REMOVAL .
    NOTE: For the model without driver monitoring system, remove the cover center UPR in the same procedure as for the driver monitoring unit assembly.
  5. Remove the grip and boot. Refer to CONTROL SYSTEMS>Select Lever>REMOVAL .
  6. Remove the cover assembly front. Refer to EXTERIOR/INTERIOR TRIM>Console Box>REMOVAL .
  7. Remove the ornament panel mid passenger and the center information display assembly. Refer to ENTERTAINMENT & MONITORING>Cockpit Display>REMOVAL>DISPLAY ASSEMBLY .
  8. Remove the data communication module.
    1. Disconnect the data communication module cord.
      G13623007Courtesy of SUBARU OF AMERICA, INC.
    2. Remove the screws and remove the data communication module.
      CAUTION: Do not drop or apply any impact to the data communication module.
      G13623008Courtesy of SUBARU OF AMERICA, INC.
      NOTE: Remove the screws on LH side in the same procedure as on the RH side.
· About lemon-mirror