lemon-mirror:
Home >> Subaru >> 2021 >> Ascent Base >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Power Rear Gate System >> Power Rear Gate Drive Unit >> Installation

Power Rear Gate Drive Unit: Installation

  1. Install the power rear gate drive unit.
    NOTE:
    • The power rear gate stay is installed on the LH side. For operation procedures, refer to the procedures for power rear gate drive unit RH.
    • Align the alignment mark on the body side with the arrow on the grommet side.

    Tightening torque: 

    16 N.m (1.6 kgf-m, 11.4 ft-lb)

  2. Install the trim panel assembly D pillar RH. Ref. to EXTERIOR/INTERIOR TRIM>Rear Quarter Trim>INSTALLATION .
  3. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
· About lemon-mirror