lemon-mirror:
Home >> Subaru >> 2021 >> Ascent Base >> Repair and Diagnosis >> Electrical >> Gauges >> Instrumentation System & Driver Information Center >> Multi-function Display (MFD) >> Installation

Multi-function Display (MFD): Installation

CAUTION:
  • Make sure the electrical connector is connected securely.
  • Make sure that the multi-function display operates normally.
  • When reusing the tether clip of the trim panel assembly A pillar, check that there is no damage to the tether clip. If the tether clip is damaged, always replace it with a new tether clip. If the tether clip is damaged, its holding force is reduced and the trim panel assembly A pillar may come off.
  • Do not reuse the tether clip of the trim panel assembly A pillar when it is removed from the vehicle. Always replace with a new part.
  • Do not reuse the upper clips of the trim panel assembly B pillar UPR. Once the clip is removed, its holding force is reduced. Be sure to replace it with a new clip.
  • Before installing the trim panel assembly A pillar, check the condition of protective non-woven fabric (white) of the curtain airbag. If it is damaged (airbag module cloth is exposed), replace the curtain airbag module assembly with a new part.
  1. Connect the connector, and install the multi-function display.
  2. Install the trim panel assembly A pillar.
  3. Install the grille speaker side.
  4. Install the grille speaker assembly CTR.
  5. Install the switch assembly hazard.
  6. Install the grille ventilation assembly center.
  7. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
· About lemon-mirror