Camera All Initialization

This is a recovery measures prepared for the data failure caused by the low battery voltage during data storage to inside the stereo camera.

Perform the camera initialization only when the camera adjustment and inspection result is NG even if the vehicle is placed correctly as shown in the flowchart described in "A: Procedure". After camera all initialization, perform camera adjustment and inspection in the same procedure as for camera replacement.

1. Using the Subaru Select Monitor, select [EyeSight All Initialization] from the work support item list of [EyeSight] and perform it. Ref. to COMMON (DIAG)>WORK SUPPORT .
2. After [Do not usually perform "EyeSight all initialization" because it will clear vehicle registration information, aiming data, diag codes, cancellation codes, etc. After implementing EyeSight all initialization, if necessary, please carry out "Clear Adjustment Value", Vehicle information registration", Aiming" etc. according to "Service Manual". Do you really want to do it?] is displayed, select [Yes].
3. When ["EyeSight all initialization" Processing Please wait] is displayed, wait until it finishes.
4. ["EyeSight all initialization" completed normally. 1) Please IG switch or key switch to OFF. 2) Wait for 5 seconds. 3) Click the OK button, exit SSM4.] is displayed after EyeSight all initialization is successfully completed, select [OK] to exit.
5. Turn the ignition switch to OFF and wait for 5 seconds.
6. Next, perform the adjustment value clear operation. Ref. to EYESIGHT>CAMERA ADJUSTMENT, INSPECTION>PROCEDURE>ADJUSTMENT VALUE CLEAR .