Auto Headlight Beam Leveler System: Procedure: Notes
CAUTION:
- If the indicator does not flash three times or the headlight beam does not operate, it can be assumed that there is an open circuit or faulty wiring in the harness of the auto headlight beam leveler control module, or headlight assembly. Perform inspection and repair according to the inspection results, then perform initialization/reinitialization again.
- Initialization: Ref. to LIGHTING SYSTEM>AUTO HEADLIGHT BEAM LEVELER SYSTEM>PROCEDURE>INITIALIZATION .
- Reinitialization: Ref. to LIGHTING SYSTEM>AUTO HEADLIGHT BEAM LEVELER SYSTEM>PROCEDURE>REINITIALIZATION .
- If any of the following conditions is met, the headlight beam may deviate. If the headlight beam deviates, perform fuse resetting. Ref. to LIGHTING SYSTEM>AUTO HEADLIGHT BEAM LEVELER SYSTEM>PROCEDURE>FUSE RESET .
- Difference has occurred to the angle of road surface between when the ignition switch is turned to OFF and when the ignition switch is turned to ON.
- Difference has occurred to the angle of road surface between when the ignition switch is turned to OFF and when the vehicle speed is 0 km/h (0 MPH).
When parts related to the auto headlight beam leveler system are removed or replaced, perform the following procedures to initialize or reinitialize.
NOTE:
Before performing initialization or reinitialization, check the following:
- The vehicle is parked on a level surface.
- The inflation pressure of tires is correct.
- The vehicle does not have load.
- Vehicle's fuel tank is fully filled.
- Refer to the following chart to determine whether to initialize or reinitialize.
| Initialization | When the auto headlight beam leveler control module was replaced with a new module. |
| Reinitialization | When the auto headlight beam leveler control module was replaced with a part from another vehicle. |