lemon-mirror:
Home >> Subaru >> 2021 >> Outback Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Fuel Injection System (2.4L)) >> Engine Coolant Temperature Sensor >> Installation

Engine Coolant Temperature Sensor: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Set a new gasket, install the engine coolant temperature sensor using the ST.
    NOTE: STRUT MOUNT SOCKET (20099PA000) can also be used.

    Preparation tool: 

    ST: STRUT MOUNT SOCKET (20399AG000)

    Tightening torque: 

    16 N.m (1.6 kgf-m, 11.8 ft-lb)

  2. Connect the connector (B) to engine coolant temperature sensor and connect the connector
    G13948360Courtesy of SUBARU OF AMERICA, INC.
  3. Install the connector (A) and clip (B).
    G13948361Courtesy of SUBARU OF AMERICA, INC.
  4. Install the clip (D) and clip (E), and connect the connector (A), connector (B) and connector (C).
    G13948362Courtesy of SUBARU OF AMERICA, INC.
  5. Install the intercooler. Ref. to INTAKE (INDUCTION) (H4DOTC)>INTERCOOLER>INSTALLATION .
  6. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  7. Fill engine coolant. Ref. to COOLING (H4DOTC)>ENGINE COOLANT>REPLACEMENT>FILLING OF ENGINE COOLANT .
· About lemon-mirror