Front Suspension And Wheel Alignment: Stabilizer: Installation: Stabilizer

CAUTION:

For parts which are not reusable, always use new parts.
Install the rubber bushing stabilizer front so that the slit does not shift to the right or left.
Install the clamp stabilizer with the peak of triangle facing the front of the vehicle.

Courtesy of SUBARU OF AMERICA, INC.

NOTE:

The rubber bushing stabilizer front can be used with its slit facing either front or rear.
The left and right clamp stabilizers differ in shape.

Set the stabilizer front to the vehicle in the reverse order of removal, and install the clamp stabilizer.
Tightening torque:

25 N.m (2.5 kgf-m, 18.4 ft-lb)
Install the stabilizer link front (bottom part).
Tightening torque:

60 N.m (6.1 kgf-m, 44.3 ft-lb)
Install the front exhaust pipe. (H4DO model) Ref. to EXHAUST (H4DO)>FRONT EXHAUST PIPE>INSTALLATION .
Install the center exhaust pipe (rear). (H4DOTC model) Ref. to CENTER EXHAUST PIPE (REAR) .
Install the under guard front. (H4DOTC model)
Tightening torque:

32 N.m (3.3 kgf-m, 23.6 ft-lb)
Install the under cover front. Ref. to EXTERIOR/INTERIOR TRIM>FRONT UNDER COVER>INSTALLATION .
Connect the ground terminal to battery sensor. (H4DO model) Ref. to REPAIR CONTENTS>NOTE > BATTERY .