Drive Plate: Installation

Temporarily attach the reinforcement drive plate, drive plate and crankshaft position sensor plate.

CAUTION: Install with the stamped mark of the crankshaft position sensor plate facing the transmission side.

NOTE: Align the knock pin hole of the crankshaft position sensor plate to the knock pin of the crankshaft to secure the knock pin.

Courtesy of SUBARU OF AMERICA, INC.

(A)	Reinforcement drive plate
(B)	Drive plate
(C)	Crankshaft position sensor plate

Secure the crank pulley with the ST1 and ST2.
Preparation tool:

ST1: PULLEY WRENCH (18355AA000)

ST2: PULLEY WRENCH PIN SET (18334AA000)

Courtesy of SUBARU OF AMERICA, INC.
Tighten the drive plate mounting bolts in the numerical order shown in the figure.
Tightening torque:

95 N.m (9.7 kgf-m, 70.1 ft-lb)

Fig 1: Drive Plate Mounting Bolts Tightening Sequence
Courtesy of SUBARU OF AMERICA, INC.
Install the transmission body. Ref. to AUTOMATIC TRANSMISSION>TRANSMISSION ASSEMBLY>INSTALLATION .