Engine Starting System & Charging System (2.5L): Generator: Installation

Temporarily install the generator.
Tighten the bolts in the numerical order as shown in the figure.
Tightening torque:

25 N.m (2.5 kgf-m, 18.4 ft-lb)

Fig 1: Generator Bolts Tightening Sequence
Courtesy of SUBARU OF AMERICA, INC.
Connect the connector and terminal B.
CAUTION: As residual anti-rust grease or dirt on the threads (bolts and nuts), terminals and seating surfaces may cause overtorque, clean and degrease them.

Tightening torque:

15.5 N.m (1.6 kgf-m, 11.4 ft-lb)
After connecting the terminal B, apply a thin coat of anti-rust grease to the terminal section.
CAUTION: This procedure is required to prevent rust and suppress sulfation.

Preparation items:

Grease: Viscotech R174 or equivalent Ref. to RECOMMENDED MATERIALS>GREASE>STARTING/CHARGING SYSTEM

Courtesy of SUBARU OF AMERICA, INC.

(A) Anti-rust grease application area
Install the V-belts. Ref. to MECHANICAL (H4DO)>V-BELT>INSTALLATION>V-BELT .
Install the air intake duct. Ref. to INTAKE (INDUCTION) (H4DO)>AIR INTAKE DUCT>INSTALLATION .
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .