Throttle Switch (TS): Notes
NOTE:
Throttle switch is used ONLY on Swift SOHC models with manual transaxle. Throttle position sensor is used on automatic transaxle models.
THROTTLE SWITCH CONTINUITY (SOHC ONLY)
| Application | Specification | |
|---|---|---|
| Between Terminals "A" & "B" | ||
| With .012" (.30 mm) Clearance At Stop Screw | Continuity | |
| With .035" (.89 mm) Clearance At Stop Screw | No Continuity | |
| With Throttle Wide Open | No Continuity | |
| Between Terminals "B" & "C" | ||
| With .012" (.30 mm) Clearance At Stop Screw | No Continuity | |
| With .035" (.89 mm) Clearance At Stop Screw | No Continuity | |
| With Throttle Wide Open | Continuity | |
| Between Terminals "A" & "C" | ||
| With .012" (.30 mm) Clearance At Stop Screw | No Continuity | |
| With .035" (.89 mm) Clearance At Stop Screw | No Continuity | |
| With Throttle Wide Open | No Continuity | |
CAUTION:
DO NOT
adjust Swift SOHC throttle stop screw to adjust idle. Throttle stop screw is factory set and is used as zero reference point for all other adjustments.