lemon-mirror:
Home >> Suzuki >> 2008 >> XL7 Base, FWD >> Repair and Diagnosis >> Transmission >> Automatic Transmission >> Repair Instructions >> Output Speed Sensor Replacement >> Installation Procedure

Installation Procedure

Fig 1: Identifying Output Speed Sensor And Bolt
G05469841Courtesy of SUZUKI OF AMERICA CORP.
  1. Apply GM T-IV automatic transaxle fluid GM P/N 88900925 to the new output speed sensor O-ring.
  2. Install the new output speed sensor O-ring onto the output speed sensor (2).
  3. Install the output speed sensor into the transmission case assembly.
    CAUTION: Refer to FASTENER NOTICE .
  4. Install the output speed sensor bolt.

    Tightening torque 

    Tighten the bolt to 5 N.m (44 lb in). 

    Fig 2: Identifying Electrical Connector
    G05469842Courtesy of SUZUKI OF AMERICA CORP.
  5. Connect the electrical connector (2) to the output shaft speed sensor.
  6. Install the battery tray. refer to BATTERY TRAY REPLACEMENT .
· About lemon-mirror