lemon-mirror:
Home >> Toyota >> 1996 >> Supra 3.0 D, Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Abs/Traction Control System >> Bleeding Brake System >> Traction Control Bleeding

Traction Control Bleeding

NOTE: Whenever the master cylinder and/or power booster is removed, the TRAC system must be bled.
  1. Ensure battery voltage is 10-14.5 volts. Disconnect electrical connector from traction control pump. Connect one end of Actuator Bleed Wire (09990-00330) to pump. Connect one end of a clear vinyl tube to bleed port on traction control actuator. Submerge other end of tube in a container half filled with clean brake fluid.
  2. Loosen bleeder plug and start engine. Connect actuator bleed wire leads to battery and allow actuator pump to run for at least 60 seconds. Tighten bleeder plug. Allow traction pump to run for about 30 seconds. Check master cylinder fluid level. Reconnect traction pump electrical connector. Turn engine off. Clear any DTCs stored. See CLEARING DTCS  under SELF-DIAGNOSTIC SYSTEM.
· About lemon-mirror